Product Description
It is cement based, polymer modified, water repellent, ready to use surface coating material which is very resistant to outdoor weather conditions because of its breathing feature thanks to its steam permeability and which can be painted after. It is dried and which provides a decorative appearance due to it special filling dimension.
Areas of Application
It is used as final layer coating on exterior thermal sheathing systems and cement plaster or as decorative coating on interior - exterior walls.
At residences, shopping centers and hospitals.
For horizontal, vertical and overhead applications.
Advantages
• Shrinkage controlled polymer modified structural decorative plaster.
• Single component, easy to apply and give shape.
• Water repellent, does not affected from water.
• It demonstrates high resistance to all kinds of climate conditions.
• Suitable for internal and external applications.
• Resistant against external impacts and frost.
• Has very good adherence and high resistance.
• It is durable, inflammable, and does not roughen.
• Can be painted after it is dried.
• Has a breathing feature thanks to its steam permeability.
• Consistent colors.
• Cost effective, hand applied no formwork is required.
Application Instructions
Surface Quality: The surfaces must be clean, smooth, solid and free of substances and residuals preventing adhesion such as all kinds of dust, grease, rust, molding oil, and detergents, ete. The surfaces must be smooth, the weak parts must be removed. lf there are cracks, pits on the surfaces or walls which the applications shall be made, they must be repaired with appropriate repairing mortars. Surface Preparation: it is recommended to apply decorative plaster primer before the application in hot weathers. Chelfix Deco is added into clean and cold water gradually and stirred approximately for 10 min. with a low speed mixer until the mixture becomes smooth. The stirred mixture is rested for 5 min. and stirred again. lf necessary, the consistency of the mixture is readjusted by adding water. The required water amount should be adjusted according to the weather conditions. Attention should be given to ensuring that the particles in the product not to be corroded when stirring with machine. Equal amount of water should be used for each lot of mortar mixture. Otherwise, pattern and tone differences may occur on the surface. Prepared mixture should be used within 2 hours depending on the weather conditions. The homogenous mixture prepared is applied on the surface properly via steel trowel and excessive material is removed from the surface in order to obtain a layer with a thickness as of the particles in the product. The pattern should be given within 10 min. at the latest after Chelfix is applied homogenously on the application surface. The pattern is given by cyclical movements with the aid of plastic or polyurethane trowel in order to obtain fine particle texture. The surface of the trowel must be scratched frequently when giving pattern. The products with same burden numbers should be used on same surfaces. Attention should be given to employ in sufficient number of persons, to apply the material continuously and without interruption until reaching to the jointing ends or detail corners so that there is not any overlapping on the large surfaces.
